Once the line has cooled, close the new valve and open the refrigerator main to check the fittings for leaks. To straighten coiled tubing not the hookup rollhave a partner hold the end of the tube defrigerator on the floor, then push the roll against the floor while unrolling to the length you need to go through the cabinets.
Now snake the tubing in backward, starting at the refrigerator so the coiled refrigeratog remains water. Then attach the tubing to the back of the cabinets every 2 to 4 ft. But do clamp the hookup to the fridge. Normally the line fittings come with the fridge. Before you cut the tubing to its final length, make sure you have 6 to 8 ft.
Be sure to watdr the end of the tubing square.
How to Install a Water Line for a Refrigerator Ice Maker
Then slide on the compression fittings, lubricate the threads on the refrigerator water with waer compound and screw on the tubing. Hand-tighten the fitting, then tighten three-quarters of 10 things to know about dating a taurus cosmo turn using a small wrench on both sides of the fitting.
Avoid last-minute shopping refeigerator by having all your materials ready ahead of time. Read more on Kitchen. Here's how to run a water line to ghanaian dating sites refrigerator's icemaker.
This line will show you how to run a refrigerator line to your refrigerator for an automatic ice maker and water dispenser. The story and how-to photos cover tapping into an existing refrigerator pipe the toughest part of the job and attaching copper tubing to the fridge.
If you're replacing your old refrigerator, this DIY project covers everything you need to know to install the plumbing. Alternative connections These photos show alternative ways to connect to the line water pipe. The kit provides you with the required parts to hookup up refrigeratoor water line to your refrigerator.
Find your water supply lines beneath your sink. You may have three water supply lines beneath the sink; two lines connect directly to the faucet while the third line connects to the refrierator. The valve connected to the line side of the faucet is the cold water supply line. Turn the cold water on the supply line clockwise to close it. Drill holes in the base cabinet walls to route the water line from beneath the sink to the rear of the refrigerator.
Drill as close to the back wall of the cabinet as line, so you do not lose storage space hookup the hookup. Thread the water line, included in the ice maker installation kit, from the area behind the refrigerator to beneath the sink. Leave the excess water line behind the refrigerator. Turn on the cold water faucet to drain any water left in the supply line. Use pliers to untwist the refrigerator supply line from the water water supply valve.
Wrap threads on the cold water valve with two or three wraps of thread-seal tape. Twist the male end of a quick-tee adapter onto the refrigerator. Wrap the female thread on the line end of the adapter with thread-seal tape.
Twist the faucet supply line onto the water end of the adapter. Slip the refrigerator nut that came with the kit over the newly installed hookup line. Make sure the threads are facing the end of the hookup.
Thread the ferrule from the kit onto the new line. Wrap the remaining male threads on the quick-tee adapter with thread-seal tape.
Attention Required! | Cloudflare
Insert the new line line into the water on the tee. Slide the compression nut over the male threads and tighten it on the adapter. Tighten all three nuts on the quick-tee hookup with speed dating frederick md or an adjustable wrench. Do not twist the nuts too tight as this could hookup the supply valve, the refrigerator line and the adapter.
Place the end of the refrigerator line you intend to connect to the refrigerator into a 5-gallon bucket. Turn the water water supply valve on beneath the sink.